NEC NP-V260X RS232 codes- Projectors - Page 9

01H : External control working 02H : Operating memory 03H : Standby 04H : On Forced on-screen mute mode 05H : Link mode working 06H : Displaying a signal other than PC Viewer 07H : -No signal08H : Displaying a test pattern or PC Card Files screen. 09H : No PC card is inserted0AH : Memory operation failed 0BH : Switcher mode working 0CH : Displaying the Entry List * When a gain adjustment error occurs 00H : Group number / sub category number is not correct. 01H : Selected gain is not available. 02H : Adjustment failed * When a logo transfer error occurs 00H : Start is not requested 01H : Cannot process due to storing 02H : Exceeds the total number of blocks required at the time of start 03H : The block number of transferred data is not consecutive. USB connection This conforms to the USB1.1 standard. Transfer speed: All speeds (supported) Endpoint: Control transfer Endpoint 0 Device class: HID class (Ver1.1) USB1.1 Standard: Universal Serial Bus Specification Revision 1.1 HID : Human Interface Device Connector Specifications 1 VBUS (Power supply) 2 D- (- Signal) 3 D+ (+ Signal) 4 GND (Ground) * Depending on the USB host controller in the personal computer, the USB connection may fail to operate. When using a USB hub, please use a self-powered type, not a bus-powered type. When using a USB hub, connection to the first stage of the USB hub is recommended. LAN connection Wired LAN port ] LAN interface Communication speed: Auto setting (10/100Mbps) Certified standard: IEEE802.3 (10BASE-T) IEEE802.3u (100BASE-TX, Auto-Negotiation) A LAN connector (8 male RJ-45 connector) 1 TD+ Transmit data (+) 2 TD- Transmit data (-) 3 RD+ Receive data (+) 4 Not used