Nady 151 VR Manual - Page 5
WLT LAVALIER BODYPACK TRANSMITTER, Operating Instructions
View all Nady 151 VR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
WLT LAVALIER BODYPACK TRANSMITTER • OFF/STANDBY/ON switch allows convenient audio muting with the transmitter "ON" • Low battery LED indicator flashes once for unit "ON"; lights steady for low battery alert • Locking 3.5mm mini-jack provides secure connection for removable microphone or instrument cable • Easily accessible input level adjust control for optimum sound Operating Instructions 1. Snap open the BATTERY COMPARTMENT (10) and insert a fresh 9V BATTERY (11), observing the correct polarity. Close the compartment. 2. The WLT is provided with a 3.5 mm LOCKING JACK (12) for connecting the microphone. Plug in either the LAVALIER/LAPEL (13) or the HEADWORN MICROPHONE (14), as supplied. To secure the connection, turn the metal slip ring on the plug clockwise to thread it on to the jack. To unplug, reverse the process. Slip the transmitter into a pocket or clip on to your clothes. To use the lavalier mic, attach it at chest level. Do not place too close to the mouth - a distance of about six inches usually works best. To use the headworn mic, place it on the head and adjust the mic boom so that the mic is about one inch to the side of the front of the mouth. (Note: The lavalier or headworn mic wire is also the transmit antenna, and rolling up or shortening the wire may reduce the effective operating range. Extend the wire fully during use, and keep it as straight as possible.) 3. Turn on the WLT by sliding the OFF/STANDBY/ON SWITCH (15) to the STANDBY position (transmitter on, audio muted) or the ON position (transmitter and audio both on). The BATTERY INDICATOR LED (16) will give a single quick flash, indicating usable battery strength. In the case of a dead or low battery, the LED either will not go on at all or will stay on continuously, indicating that the battery should be replaced with a fresh one. 4. The microphone is now ready to use. The TX LED INDICATOR (4) on the 151 VR receiver should now be lit, indicating a received signal from the transmitter. When ready to speak, slide the transmitter switch to the ON position and adjust the volume of the receiver as per instructions on page 5. Re-position the microphone farther from the source or adjust the AUDIO INPUT LEVEL CONTROL (17) if the monitored volume is to loud or distorted afer adjusting the receiver as per instructions on page 5. 6 (Note: Microphone elements can easily be destroyed by the buildup of salts and minerals from perspiration and saliva. It is good practice to put a windscreen on the mic element at all times to protect it.) (17) Audio Input Level Control (16) Battery Indicator LED (15) OFF/STANDBY/ ON Switch (12) 3.5 mm Locking Jack (14) Headworn Microphone (13) Lavalier/Lapel (10) Battery Compartment Opening Battery Compartment 7 (11) 9V Alkaline Battery