Netgear AC1900-WiFi Installation Guide - Page 11
Connect an Ethernet-Enabled Device, Use the Extender in Access Point Mode
 |
View all Netgear AC1900-WiFi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Connect an Ethernet-Enabled Device After the extender is connected to your existing WiFi network, you can connect a wired device to the extender using an Ethernet cable. That device can then access your existing network through the WiFi connection. Use the Extender in Access Point Mode You can set up your extender as a WiFi access point. Tri-band WiFi is available when your extender is in access point mode. The following instructions assume that you did not previously set up your extender. 11
-
1 -
2
-
3
-
4
-
5
-
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13 -
14 -
15 -
16 -
17
-
18
-
19
-
20
 |
 |
11
Connect an Ethernet-Enabled Device
After the extender is connected to your existing WiFi network, you can
connect a wired device to the extender using an Ethernet cable. That
device can then access your existing network through the WiFi connection.
Use the Extender in Access Point Mode
You can set up your extender as a WiFi access point. Tri-band WiFi is
available when your extender is in access point mode.
The following instructions assume that you did not previously set up your
extender.