Netgear AC1900-WiFi Installation Guide - Page 17

4. Click the NEW EXTENDER SETUP button. When prompted, complete the fields on the page to set up your login credentials again. How do I restore the extender to its factory default settings? 1. Use a sharp object such as a pen or straightened paper clip to press and hold the Factory Reset button on the extender for at least five seconds until the Power LED blinks amber. 2. Release the Factory Reset button and wait for the extender to reboot. The extender resets and returns to the factory default settings. I enabled a WiFi MAC filter, wireless access control, or access control list (ACL) on my router. What should I do when installing the extender? When a device connects through the extender to your router, the MAC address of the device shown on the router is translated to another MAC address. If your router's MAC filter, wireless access control, or ACL is enabled, the device connects to the extender but cannot get an IP address from the extender and cannot access the Internet. To allow your device to receive an IP address from the extender and access the Internet, you must provide the translated MAC address to the router. 17