Netgear AFT603 Installation Guide - Page 12
Computer in DHCP Client Mode Without a DHCP, Server
View all Netgear AFT603 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
When configuring your switch, connect your switch to one of the numbered ports on the switch's front panel. Do not connect to the Out-of-Band (OoB) port for initial switch configuration. Note: Use the OoB port to manage the switch only after the switch has been configured for your network. For more information about switch management using the OoB port, see the M6100 CLI Reference Manual and the M6100 Software Administration Manual. To configure your switch using web management, use one of the following procedures, depending on how your Windows computer is set up: • Computer in DHCP Client Mode Without a DHCP Server. • Computer with a Static IP Address. • Computer in DHCP Client Mode with DHCP Server. Computer in DHCP Client Mode Without a DHCP Server The switch assumes a default IP address of 169.254.100.100 and a subnet mask of 255.255.0.0. The switch is in the same subnet used by the computer NIC port when in DHCP-client mode without a DHCP server present. Use this IP value to log in to the switch. 12