Netgear EN108TP EN104TP Installation Guide - Page 5

LEDs The table below describes the activity of the LEDs. Label Color Activity Description Pwr (Power) Col (collision) Link (located on the top left corner of each vista 10BASE-T port) Rx (located on the top right corner of each vista 10BASE-T port) Green Amber Green Green On Blinking On Blinking Power is supplied to the hub. Data collision is occurring on the network. Note that occasional collisions are normal. The link between this port and the connected device is good. There is incoming data on the port. Normal/Uplink Push Button The Normal/Uplink push button allows you to select Normal (MDI-X) wiring for direct PC connection. The push button also allows you to select Uplink (MDI) wiring for connection to a hub or a switch through port 4 on the Model EN104TP hub, port 6 on the Model EN106TP hub, or port 8 on the Model EN108TP hub. This uplink configuration eliminates the need to use a crossover cable. The other 10BASE-T ports are permanently configured for normal wiring for connection to a PC. Rear Panel The rear panel of the hub has a ground clip and a receptacle for the power adapter. Power receptacle 5Vdc 800mA -+ 8730FA Model EN104TP/EN106TP/EN108TP Ethernet Hub Installation Guide