Netgear GS724TS GS7xxTS Hardware manual - Page 27
Device Hardware Interfaces, RJ-45 Ports - fan
UPC - 606449049442
View all Netgear GS724TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
GS700TS Hardware Installation Guide Table 3-2. System LEDs (continued) LED Stack Down LED Power LED Fan LED Designation Indicates the Down stacking port LED designations • Off - Indicates the Down stacking port link is down. • Solid Green - Indicates the Down stacking port link is up. • Flashing Green - Packet transmission or reception is occurring on the Down stacking port. • Off - Power is disconnected. • Solid Green - Power is supplied to the switch and is operating normally. • Solid Green - The fan is operating normally. • Solid Red - The fan is not operating normally. Device Hardware Interfaces This section provides information for the following hardware interfaces: • RJ-45 Ports • SFP GBIC Module • Factory Defaults Button RJ-45 Ports RJ-45ports are auto-sensing ports. When inserting a cable into an RJ-45 port, the switch automatically ascertains the maximum speed (10 or 100 or 1000 Mbps) and duplex mode (half- or full-duplex) of the attached device. All ports support only Unshielded Twisted-Pair (UTP) cable terminated with an 8-pin RJ-45 plug. To simplify the procedure for attaching devices, all RJ-45 ports support Auto Uplink. This technology allows attaching devices to the RJ-45 ports with either straight-through or crossover cables. When inserting a cable into the switch's RJ-45 port, the switch automatically: • Senses whether the cable is a straight-through or crossover cable. • Determines whether the link to the attached device requires a "normal" connection (such as when connecting the port to a PC) or an "uplink" connection (such as when connecting the port to a router, switch, or hub). Physical Description v1.0, November 2007 3-23