Netgear WG302v1 Application Notes - Point to Multi-Point Bridging - Page 3

Configuration, Testing

Get Netgear WG302v1 - ProSafe 802.11g Wireless Access Point PDF manuals and user guides View all Netgear WG302v1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

In the Remote MAC address fields, put the MAC address of the other two access points; you'll be able to find the MAC address of each access point underneath the device, on its tag - Or alternatively in the 'General' section of the GUI. CONFIGURATION - Secondary "Slave" units: Once this access point has its basic configuration set and you've confirmed it to be working properly, go to the 'Access Point Settings' section and enable wireless bridging and repeating, select 'Wireless Point to Point Bridge' and enable Wireless Client Association (If you want stations to be able to connect to this particular access point). In the 'Remote MAC Address' field insert the MAC address of the MASTER unit. TESTING - Verifying the connection: To verify this connection, try connecting wirelessly to the main unit and using the 'ping' DOS command to the IP address of the other access points. If the replies are successful, you'll know the configuration was successful.

  • 1
  • 2
  • 3
In the Remote MAC address fields, put the MAC address of the other two access points; you’ll be
able to find the MAC address of each access point underneath the device, on its tag
–
Or
alternatively in the
‘General’ section of the GUI.
CONFIGURATION
–
Secondary “Slave” units:
Once this access point has its basic configuration set and you’ve confirmed it to be working
properly, go to the ‘Access Point Settings’ section and enable wireless bridging and
repeating,
select ‘Wireless Point to Point Bridge’ and enable Wireless Client Association (If you want
stations to be able to connect to this particular access point).
In the ‘Remote MAC Address’ field insert the MAC address of the MASTER unit.
TESTING
–
Verifying the connection:
To verify this connection, try connecting wirelessly to the main unit and using the ‘ping’ DOS
command to the IP address of the other access points. If the replies are successful, you’ll know
the configuration was successful.