Nikon D500 Users Manual - English for customers in Asia Oceania the Middle Eas - Page 144

A The Memory Buffer The camera is equipped with a memory buffer for temporary storage, allowing shooting to continue while photographs are being saved to the memory card. Note, however, that frame rate will drop when the buffer is full (tAA). The approximate number of images that can be stored in the memory buffer at current settings is shown in the exposurecount displays in the viewfinder and control panel while the shutter-release button is pressed halfway. The illustration at right shows the display when space remains in the buffer for about 99 pictures. While photographs are being recorded to the memory card, the memory card access lamp will light. Depending on shooting conditions and memory card performance, recording may take from a few seconds to a few minutes. Do not remove the memory card or remove or disconnect the power source until the access lamp has gone out. If the camera is switched off while data remain in the buffer, the power will not turn off until all images in the buffer have been recorded. If the battery is exhausted while images remain in the buffer, the shutter release will be disabled and the images transferred to the memory card. A See Also For information on choosing the order in which the photos in each burst are displayed after shooting, see After burst, show (0 282). For information on choosing the maximum number of photographs that can be taken in a single burst, see Custom Setting d2 (Max. continuous release, 0 297). For information on the number of pictures that can be taken in a single burst, see page 387. 118