NordicTrack 9600 Eng Bike Canadian English Manual - Page 8
How To Set Up The Recumbent Bike
View all NordicTrack 9600 Eng Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
HOW TO SET UP THE RECUMBENT BIKE HOW TO MOVE AND LEVEL THE RECUMBENT BIKE Before moving the recumbent bike, make sure that the power cord is unplugged. Note: If a CATV cable is connected to the recumbent bike, it may be necessary to disconnect the cable if the recumbent bike will be moved far. Due to the size and weight of the recumbent bike, moving it requires two persons. While one person lifts the indicated end, firmly hold the handlebar and tip the recumbent bike forward until it rolls on the front wheels. Carefully move the recumbent bike to the desired location and then lower it back to the level position. CAUTION: To reduce the risk of injury, use extreme caution while moving the recumbent bike. Do not attempt to move the recumbent bike over uneven surfaces. If the recumbent bike rocks slightly during use, turn the Levelling feet under the rear of the frame until the rocking motion is eliminated. Lift Here Handlebar Wheels Levelling Feet HOW TO ADJUST THE SEAT To adjust the seat, lift the seat latch, slide the seat forward or backward to the desired position, and then push the seat latch back down. Seat Latch HOW TO CONNECT THE POWER CORD If the recumbent bike has a Basic console, it can be used with or without the included power cord. If the recumbent bike has a Workout TV console, the power cord must be used for the TV to be operated. To use the power cord, first plug one end of the power cord into the jack on the front of the recumbent bike. Plug the other end of the power cord into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. Power Cord Jack 7