NordicTrack Gx 4.7 R Instruction Manual - Page 11

10. Tip: Avoid pinching the Main Wire (77). Hold the Upright (4) against the Frame (1). Attach the 10 Upright with four M8 x 15mm Screws (24); start 77 4 all the Screws, and then tighten them. 24 Next, orient the Accessory Tray (5) and the Avoid 16 Console Cover (16) as shown. pinching Tip: Avoid pinching the Main Wire (77). the Main Wire (77) 5 Slide the Accessory Tray (5) and the Console Cover (16) onto the Upright (4). Then, press the 1 Accessory Tray onto the Left and Right Front Shields (57, 58). 57, 58 11. Untie and discard the wire tie on the Main Wire (77). While a second person holds the Handlebar (14) near the Upright (4), route the Main Wire (77) through the notch (B) in the Upright and through the hole (C) in the Handlebar. Tip: Avoid pinching the Main Wire (77). Insert the Pivot Bracket (17) into the Upright (4). Attach the Pivot Bracket with two M8 x 63mm Bolts (26) and two M8 Locknuts (25). Make sure that the Locknuts are in the hexagonal holes (D). 11 C 77 26 14 17 4 Avoid pinching the B Main Wire (77) 25 D 11