NordicTrack Summit 4500 English Manual - Page 6

ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench and your own phillips screwdriver and wire cutters . Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. 1. With the help of a second person, carefully raise the Uprights (69) until the treadmill is in the position shown. 1 Insert one of the Extension Legs (102) into the treadmill as shown in the inset drawing. Make sure that the 69 Extension Leg is turned so the Base Pad (99) is on the bottom. Note: It may be helpful to tip the Uprights (69) forward as you insert the Extension Leg. Insert the other Extension Leg (not shown) in the same 69 way. 102 99 2. Press the Lock Knob Sleeve (70) into the left Upright (69). Make sure that the Lock Pin Collar (72) and the Spring (71) are on the Lock Pin (74). Insert the Lock Pin into Lock Knob Sleeve (70) and the left Upright (69). Press the Lock Knob Spacer (117) onto the left Upright. Tighten the Lock Knob (68) onto the Lock Pin. 2 68 117 69 70 71 72 74 3. With the help of a second person, tip the Uprights (69) down as shown. Make sure that the Extension Legs (102) remain in the Uprights. Attach each Extension Leg (102) with two Screws (100) as shown. With the help of a second person, carefully tip the Uprights (69) back to the vertical position. Note: A replacement Base Pad (99) may be included. Use the Base Pad to replace any Base Pad that becomes worn. 3 69 99 6 99 Frame 100 102 69 100 102