Oki B710dn Maintenance Manual

Oki B710dn Manual

Get Oki B710dn PDF manuals and user guides View all Oki B710dn manuals
Add to My Manuals
Save this manual to your list of manuals

Oki B710dn manual content summary:

  • Oki B710dn | Maintenance Manual - Page 1
    B700 Series 200K Page Maintenance Kit Instructions The following document outlines the procedures to install the fuser assembly, BTR roller, and retard roller assemblies included in the B710/720 and the B730 200K page maintenance kits. B710/720 Kit Part Number - 58284203 B730 Kit Part Number -
  • Oki B710dn | Maintenance Manual - Page 2
    Installing the New Fuser Assembly 1. Line up the connector on the fuser with the connector on the printer and insert the new fuser. Fuser Connector Printer Connector 2. Lock the Fuser in position by pushing up on the orange tabs. 2
  • Oki B710dn | Maintenance Manual - Page 3
    B710 B720 and B730 Fuser Counter Reset Procedure -Instructions for Resetting the Maintenance Counters- First, enter the diagnostic mode in order to do a maintenance counter reset. To enter the Diagnostics area: Turn the printer power OFF. Press and Hold the MENU^ and Enter buttons. Turn the printer
  • Oki B710dn | Maintenance Manual - Page 4
    Replacing the Retard Rollers 1. Gently push the notch on the tab away from the groove in the shaft. 2. While holding the tab clear of the shaft move the roller toward the groove in to remove. 3. Repeat the procedure to remove the rollers at all three locations shown below. 150 Paper Cassette
  • Oki B710dn | Maintenance Manual - Page 5
    150 Feeder Assembly 550 Feeder Assembly 550 Paper Cassette 5
  • Oki B710dn | Maintenance Manual - Page 6
    Installing the new Retard Rollers 1. Install the roller by aligning the shaft with the opening in the roller and push the roller over the groove in the shaft until the notch on the tab locks into place. 6
  • Oki B710dn | Maintenance Manual - Page 7
    BTR Kit Instructions The following document outlines the procedures to install the new BTR assembly. and pull out. 3. Now grab from the center of the BTR and remove it through the top of the printer. Final Step: 4. Install the new BTR assembly. When installing the new BTR, the gear should be on the
  • Oki B710dn | Maintenance Manual - Page 8
    59412901 © 2012 OKI Data Americas, Inc. 8
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
1
B700 Series 200K Page
Maintenance Kit Instructions
The following document outlines the procedures to install the fuser assembly, BTR roller,
and retard roller assemblies included in the B710/720 and the B730 200K page
maintenance kits.
B710/720 Kit Part Number - 58284203 B730 Kit Part Number - 58284204
Fuser Replacement Procedure
Removing the Old Fuser Assembly:
NOTE: If the unit was recently running please turn off and allow 30 minutes for the fuser
to cool down before starting the replacement procedure. Fuser gets extremely
HOT
.
1.
If there is a duplexer installed on the unit press button to release the duplexer
assembly and drop into an open position.
2.
Squeeze the two tabs to open the rear cover.
3.
Push down on both of the orange tabs to release and remove the fuser.