Oki C941dn C941dn Safety/Warranty/Regulatory Guide - Page 21
Fire-fighting measures, Accidental release measures, Handling and storage
View all Oki C941dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
5. Fire-fighting measures Extinguishing Media: Suitable Extinguishing Media Unsuitable Extinguishing Media Special Hazards Hazardous Combustion Products Advice for Fire-fighters : Carbon dioxide, water, form, dry chemical. : None. : It may form explosive dust-air mixtures when finely dispersed in air. : Toner, like most organic powders, is capable of creating a dust explosion when particles are dispersed. Carbon monoxide and carbon dioxide are hazardous resulting gases. : Wear gloves, glasses and a mask if necessary. 6. Accidental release measures Personal Precautions, : Protective Equipment and Emergency Procedures Environmental Precautions :: Methods and Material for Containment and Cleaning Up Reference to Other Sections : Avoid dust formation. Do not breathe dust. Wear personal protective equipment as described in Section 8. Do not discharge into drains. Eliminate source of ignition and flammables. Vacuum or sweep the material into a sealed container. If a vacuum cleaner is used, it must be dust explosion-proof. Dispose of the material in accordance with Federal/state/local requirements. Refer to section 13. 7. Handling and storage Precautions for Safe Handling Conditions for Safe Storage, Including Any Incompatibilities Specific End Uses : Keep out of reach of children. Avoid dust formation. Handle in adequately ventilated areas. Do not breathe dust. Do not get in eyes or on skin. Keep away from excessive heat and sources of ignition such as sparks and open flames. Ensure all the equipment is electrically earthed/grounded before beginning operation. : Keep out of reach of children. Keep container closed and store at room temperature. Keep away from excessive heat and sources of ignition. Do not store with strong oxidizers. : This product is a toner used in printers/copiers. 8. Exposure controls/personal protection Control Parameters: Product toner USA OSHA PEL Total dust: 15mg/m3 Respirable fraction: 5mg/ m3 ACGIH TLV Inhalable particulate: 10mg/m3 Respirable particulate: 3mg.m3 EU OEL Not established DFG MAK Inhalable fraction: 4mg/m3 Respirable fraction: 1.5mg/ m3 Ingredient(s) Amorphous silica Titanium dioxide USA OSHA PEL 20mppcf* or 80/%Sio2 mg/ m3 (* million particles per cubic foot) Total dust: 15mg/m3 ACGIH TLV Not listed 10mg/m3 EU OEL Not established Not established DFG MAK Inhalable fraction: 4mg/m3 Not established 21 - English