Olympus C 700 C-700 UZ Reference Manual (10.2 MB) - Page 20

How to use this reference manual The instructions in this manual use a series of numbers for each operating procedure and button/dial illustration. Operate the camera in the order of these numbers. Set the Mode dial to the position shown in the illustration. In this example, you would set . Erasing pictures Ⅵ Check the following before erasing pictures. ● Make sure the card is not write-protected. If it is, remove the write-protect seal. ● NEVER open the card cover, eject the card, remove the batteries, or pull out the plug when the card access lamp is blinking during picture erasure. Doing so may destroy data stored on the card. 1 Set the Mode dial to . 2 The card access lamp blinks and stored pictures areread out. After that, the last recorded picture appears. Select the picture you want to erase. Displays the next picture. Jumps to the picture 10 frames ahead. HQ Means "Press this button". Displays the previous picture. '01.12.23. 21:56 24 Jumps to the picture10 frames behind. 3 Press the button. (erase) 4 When the ERASE 5 Press to erase the screen asking you to picture. confirm the erasure appears, press Ñ to select YES. If a button turns black, this means you should press it as part of the step. ERASE YES N O SELECT GO The selected setting is framed in green. Ⅵ To cancel erasure Press ñ on the Arrow pad to select NO, and press or the button. The buttons used in the instruction are displayed at the bottom of the screen illustration. Press Ññ on the Arrow pad to select an item. Ñ, ñ, É and í used in Ñ instructions correspond to the buttons on the Arrow pad as shown.É í Press to save setting/selection. ñ 20