Olympus C-720 C-720 Ultra Zoom Reference Manual (5 MB) - Page 126
Troubleshooting Cont.
UPC - 072874309558
View all Olympus C-720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Chapter 10 Troubleshooting (Cont.) POSSIBLE CAUSES CORRECTIVE ACTION REF. PAGE No picture is taken when the shutter button is pressed. 1 The mode dial is set to . 2 The memory gauge is full. 3 The flash has not finished charging. 4 The card access lamp blinks after shooting in the mode. 5 There is a problem with the card. 6 The card is full. 7 The batteries ran out of power. 8 The viewfinder/monitor indications disappear, or only the battery check lights up. 9 A write-protect adhesive seal is placed on the card or there is no card in the camera. 1 Set the mode dial to any position except . 2 Wait until there is room in the memory gauge. 3 Remove your finger from the shutter button and wait until the flash charge mark stops blinking. Take your shot again. 4 The recorded movie image data is being written to the card. You can start shooting again when the card access lamp stops blinking. 5 See the error code chart. 6 Erase unwanted pictures or insert a new card. Before erasing, download important images to a PC. 7 Replace the batteries with new ones. 8 Replace the batteries with new ones. (Do not open the battery compartment cover when the card access lamp is blinking.) 9 Insert a new card in the camera. P. 44 P. 16 P. 63 P. 57 P. 132 P. 26 P. 21 P. 21 P. 26 125