Olympus D-550 D-550 Zoom Reference Manual (4.8MB) - Page 131
If you want the flash to fire on a brightly, The subject is
UPC - 050332138131
View all Olympus D-550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Troubleshooting The batteries ran out of power during shooting or while the images were being written to the card. (Only the battery check indicator blinks.) The memory gauge is full. A write-protect seal is attached to the card. There is a problem with the card. Replace the batteries with new ones. Wait until there is room in the memory gauge. Insert a new card or remove the write-protect seal. Refer to "Error codes". p.14 p.12 p.18 p.127 The flash does not fire. Possible cause The flash has not popped up fully. The flash is set to the flash off mode. The subject is illuminated. Sequential shooting or movie mode is set. Panorama mode is set. Corrective action Be careful not to press the flash down with your finger. Make sure it has popped up fully before taking pictures. Select a flash mode other than flash off. If you want the flash to fire on a brightly illuminated subject, set the flash to fill-in mode. The flash does not fire in sequential shooting or movie mode. Set in the DRIVE menu. The flash does not fire in panorama mode. Cancel the panorama mode. Ref. Page p.54 p.54 p.54 p.49, 62 p.64 The monitor is not clear. Possible cause Corrective action The brightness is not adjusted properly. Select in the mode menu and then adjust the brightness. The monitor is exposed Block the sunlight with your hand. to direct sunlight. Ref. Page p.113 - 8 Troubleshooting 130