Onkyo ND-S1 User Manual English - Page 7

Using the Remote Controller, Replacing the Battery

Page 7 highlights

Using the Remote Controller Aiming the Remote Controller RC-755E Remove the battery-protect tab before use. Point the included remote controller toward the ND-S1's remote control sensor, as shown. Remote control sensor ND-S1 Appr(o1x6.f5t.m) 30° STANODNB/Y iPod/PC PLAYLIST SHUFFLE ALBUM REPEAT RC-755E UNSSYYNNCC/ ON/STANDBY STANDBY 30° iPod PC UNSSYYNNCC/ Replacing the Battery The included remote controller uses a CR2025 type battery. Always use with the same type. 1. To open the battery compartment, press the small hollow and slide open the cover. 2. While pressing the tab as shown, slide out the old battery. 3. Slide the new battery into the compartment with the positive (+) side facing up. 4. Slide the cover shut. Notes: • The remote controller may not work reliably if the ND-S1 is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing. • If another remote controller of the same type is used in the same room, or the ND-S1 is installed close to equipment that uses infrared rays, the remote controller may not work reliably. • Don't put anything on top of the remote controller, such as a book or magazine, because a button may be pressed continuously, thereby draining the battery. • The remote controller may not work reliably if the ND-S1 is installed in a rack behind colored glass doors. Keep this in mind when installing. • The remote controller will not work if there's an obstacle between it and the ND-S1's remote control sensor. Notes: • If the remote controller doesn't work reliably, try replacing the battery. • If you intend not to use the remote controller for a long time, remove the battery to prevent damage from leakage or corrosion. • An expired battery should be removed as soon as possible to prevent damage from leakage or corrosion. • Misuse of lithium batteries may cause a fire or chemical burn. Always keep out of reach of children. Never disassemble, charge, heat above 100°C, or incinerate. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

7
Using the Remote Controller
Point the included remote controller toward
the ND-S1’s remote control sensor, as shown.
Notes:
The remote controller may not work reliably
if the ND-S1 is subjected to bright light, such
as direct sunlight or inverter-type fluores-
cent lights. Keep this in mind when installing.
If another remote controller of the same type
is used in the same room, or the ND-S1 is
installed close to equipment that uses infra-
red rays, the remote controller may not work
reliably.
Don’t put anything on top of the remote con-
troller, such as a book or magazine, because a
button may be pressed continuously,
thereby draining the battery.
The remote controller may not work reliably
if the ND-S1 is installed in a rack behind col-
ored glass doors. Keep this in mind when
installing.
The remote controller will not work if there’s
an obstacle between it and the ND-S1’s
remote control sensor.
The included remote controller uses a CR2025
type battery. Always use with the same type.
1.
To open the battery
compartment, press
the small hollow and
slide open the cover
.
2.
While pressing the
tab as shown, slide
out the old battery.
3.
Slide the new battery
into the compart-
ment with the posi-
tive (+) side facing up
.
4.
Slide the cover shut.
Notes:
If the remote controller doesn’t work reliably,
try replacing the battery.
If you intend not to use the remote controller
for a long time, remove the battery to pre-
vent damage from leakage or corrosion.
An expired battery should be removed as
soon as possible to prevent damage from
leakage or corrosion.
Misuse of lithium batteries may cause a fire
or chemical burn. Always keep out of reach
of children. Never disassemble, charge, heat
above 100°C, or incinerate.
CAUTION:
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equiv-
alent type.
Aiming the Remote Controller
Remove the battery-protect tab before use.
RC-755E
30°
30°
Approx. 5 m
(16 ft.)
Remote control sensor
ND-S1
Replacing the Battery