Onkyo ND-S1 User Manual English - Page 9

Inserting Your iPod into the ND-S1 Prepare the adapter that came with your iPod. 1. Gently push down and slide open the dock cover on the ND-S1. SUYNNSCY/ NC PC iPod ON/STANDBY STANDBY iPod TRANSPORT 2. Insert the adapter supplied with your iPod, then push your iPod firmly onto the ND-S1's dock connector. Adapter supplied with iPod ON/STANDBY STANDBY SUYNNSCY/ NC PC iPod iPod TRANSPORT Notes: • If the [iPod] indicator does not light up after you've inserted your iPod, this means that your iPod is not properly seated on the dock connector. Make sure your iPod is seated properly on the dock connector. • To prevent dock connector damage, don't twist your iPod when inserting or removing it, and be careful not to knock your iPod while it's inserted. • Don't use your iPod with any other accessories, such as FM transmitters and microphones, because they may cause a malfunction. ■ Removing the iPod Adapter To remove the iPod adapter from the ND-S1, insert a small flathead screwdriver into the slot, and lift it out, as shown below. Notes: • If you use a case with your iPod, always remove it before you insert it. Otherwise, it may not connect properly and a malfunction may occur. • Do not insert your iPod into the ND-S1 without the adapter that came with it, as it may put unnecessary strain on the iPod or ND-S1's dock connector, causing permanent damage. When you insert your iPod, the ND-S1 works as follows depending on the status of your iPod. • iPod not playing: The ND-S1 starts charging your iPod and the STANDBY indicator flashes slowly. • iPod playing: The ND-S1 turns on, the [iPod] indicator lights up blue, and your iPod continues playing. 9