Onkyo TX-NR7100 9.2-Channel THX Certified AV Receiver Instruction Manual - Eng - Page 15
ZONE B LINE OUT jacks, 12V TRIGGER OUT jack
View all Onkyo TX-NR7100 9.2-Channel THX Certified AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Rear Panel 8K 8K 4K 8K HDCP 2.3 16. SPEAKERS terminals: Connect speakers with speaker cables. (North American models support banana plugs. Use a plug 4 mm in diameter. Y plug connection is not supported) 17. SUBWOOFER PRE OUT jacks: Connect a powered subwoofer with a subwoofer cable. Up to two powered subwoofers can be connected. The same signal is output from each SUBWOOFER PRE OUT jack. 18. ZONE 2 LINE OUT jacks: Output audio signals with an analog audio cable connected to an integrated amplifier in a separate room (ZONE 2). ZONE B LINE OUT jacks: Simultaneously output the same audio source as the speakers (ZONE A) connected to this unit by connecting this unit to wireless headphones, wireless speaker transmitter, etc., using an analog audio cable. 11. GND terminal: Connect the ground wire of the turntable. 12. AUDIO IN jacks: Input AV component audio signals with an analog audio cable. 13. 12V TRIGGER OUT jack: Connect a device equipped with a 12V trigger input jack to enable power link operation between the device and this unit. ( →p61) 14. IR IN port: Connect a remote control receiver unit. ( →p60) 15. PRE OUT FRONT jacks (European, Australian and Asian models): Connect to a power amplifier. ( →p46) FRONT PRE OUT 15