Onkyo TX-SR308 Owner Manual - Page 39

Note • Enter the appropriate remote control code before using the AV receiver's remote controller for the first time (➔ 41). • Connect the RI Dock to the AV receiver with an V cable (➔ 37). • Set the RI Dock's RI MODE switch to "HDD" or "HDD/ DOCK". • Set the AV receiver's Input Display to "DOCK" (➔ 20). ■ System Function System On When you turn on the AV receiver, the ND-S1, RI Dock and iPod turn on automatically. In addition, when the ND-S1, RI Dock and iPod are on, the AV receiver can be turned on by pressing ON/STANDBY. Auto Power On If you press the remote controller's  while the AV receiver is on Standby, the AV receiver will automatically turn on, select your iPod as the input source, and your iPod will start playback. Direct Change If you start iPod playback while listening to another input source, the AV receiver will automatically switch to the input to which the ND-S1 and RI Dock is connected. Other Remote Controllers You can use the remote controller that came with the AV receiver to control other iPod functions. The available functionality depends on the AV receiver. iPod Alarm If you use the Alarm function on your iPod to start playback, the AV receiver will turn on at the specified time and select your iPod as the input source automatically. Note • Linked operations do not work with video playback or when the alarm is set to play a sound. • If you use your iPod with any other accessories, iPod playback detection may not work. • This function only works when the Standard mode is set to On. ■ Operating Notes • Use the AV receiver's volume control to adjust the playback volume. • While your iPod is inserted in the ND-S1 and RI Dock, its volume control has no effect. • If you do adjust the volume control on your iPod while it's inserted in the ND-S1 and RI Dock, be careful that it's not set too loud before you reconnect your earphones. Controlling Your iPod By pressing REMOTE MODE that's been programmed with the remote control code for your Dock, you can control your iPod in the Dock with the following buttons. See (➔ 41) for details on entering a remote control code. See to the Dock's instruction manual for more information. ■ UP-A1 Dock PORT is preprogrammed with the remote control code for controlling a Dock with Universal Port connector. You can control your iPod when "PORT" is selected as the input source. Without the RI Control You must enter a remote control code 82990 first (➔ 41). ■ ND-S1 • Set the ND-S1 iPod/PC mode to "iPod". ■ RI Dock • Set the RI Dock's RI MODE switch to "HDD" or "HDD/DOCK". • ON/STANDBY may not work with a remote control code (without V). In this case, make an V connection and enter a remote control code 82351 (with V). With the RI Control In this case, make an V connection and enter a remote control code 82351 (with V). • Set the AV receiver's Input Display to "DOCK" (➔ 20). Note • On the 5th generation iPod and iPod nano, the click wheel is disabled during playback. For ND-S1, use iPod to start and stop playback and the remote controller to control other iPod functions. En 39