Onkyo TX SR803 Owner Manual - Page 46
Changing the Input Display, Minimum Speaker Impedance
UPC - 751398006784
View all Onkyo TX SR803 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
5943@&OCPPL 1BHF 'SJEBZ "VHVTU First Time Setup-Continued Changing the Input Display If you connect an -capable Onkyo MiniDisc recorder, CD recorder, or next generation HDD-compatible component to the TAPE IN/OUT or VIDEO 3 IN jacks, for to work properly, you must change this setting. This setting can only be changed on the AV receiver. STANDBY/ON POWER STANDBY ZONE 2 ON OFF PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 PHONO TAPE TUNER CD DISPLAY MASTER VOLUME PUSH TO OPEN 1, 2 1, 2 iPod photo: If you're using an iPod photo with the DS-A1 Remote Interactive Dock, connect the DS-A1 to the VIDEO 3 IN jacks. 1 TAPE Press the [TAPE] or [VIDEO 3] input selector button so that "TAPE" or "VIDEO3" appears on the display. or VIDEO 3 Minimum Speaker Impedance If you change this setting, you must run the automatic speaker setup again (see page 40). If the impedance of any speaker is 4 ohms or more but less than 6, set the Minimum Speaker Impedance to 4 ohms. Note: Before you change this setting, turn down the volume. 1 RECEIVER Press the [RECEIVER] button, followed by the [SETUP] button. The main menu appears onscreen. 2 ENTER ENTER Use the Up and Down [ ]/[ ] buttons to select "3. Speaker Setup," and then press [ENTER]. The Speaker Setup menu appears. 3.Speaker Setup 01.Speaker Impedance 2.Speaker Configuration 3.Speaker Distance 4.Level Calibration 5.THX Audio Setup 6.Equalizer Settings 2 TAPE or VIDEO 3 Press and hold down the [TAPE] or [VIDEO 3] input selector button (about 3 seconds) to change the setting. Repeat this step to select MD, CDR, or HDD. For the TAPE input selector, the setting changes in this order: TAPE → MD → CDR → HDD → For the VIDEO 3 input selector, the setting changes in this order: VIDEO 3 → HDD → VIDEO 3 → Note: HDD can be selected for the TAPE input selector or VIDEO 3 input selector, but not both at the same time. 3 4 ENTER 5 Use the Up and Down [ ]/[ ] buttons to select "Speaker Impedance," and then press [ENTER]. Use the Left and Right [ ]/[ ] buttons to select: 4 ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6. 6 ohms: Select if the impedances of all speakers are between 6 and 16 ohms. Press the [SETUP] button. Setup closes. Notes: • This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. 46