Onkyo TX SR803 Owner Manual - Page 81

5943@&OCPPL 1BHF  'SJEBZ "VHVTU Advanced Setup-Continued Digital Input Signal Formats Normally, the AV receiver detects the signal format automatically. However, if you experience either of the following issues when playing PCM or DTS material, you can specify the signal format as either PCM or DTS: • If the beginnings of tracks from a PCM source are cut off, try the PCM setting. • If noise is produced when fast forwarding or rewind- ing a DTS CD, try the DTS setting. RECEIVER ENTER ON STANDBY I T V INPUT V1 V2 V3 1 2 3 + V4 MULTI CH DVD T V CH 4 5 6 - CD TAPE TUNER 7 8 9 PHONO T V VOL +10 0 CLEAR --/--- 10 11 12 INPUT SELECTOR MACRO 1 2 3 ZONE2 RECEIVER TAPE/AMP REMOTE MODE DVD CD HDD TV DIMMER + CH DISC ALBUM - VCR CABLE CDR TOP MENU MENU ENTER SAT MD SLEEP VOL PREV CH DISPLAY RETURN SET UP MUTING REC PLAYLIST RANDOM SETUP 1 RECEIVER Press the [RECEIVER] REMOTE MODE button, followed by the [SETUP] button. The main menu appears onscreen. 2 ENTER Use the Up and Down [ ]/[ ] buttons to select "2. Digital Input," and then press [ENTER]. 3 ENTER ENTER Use the Up and Down [ ]/[ ] buttons to select an input source that's assigned to a digital input (opt, coax, or HDMI), and then press [ENTER]. The Digital Format menu appears. 2-1.Digital Format a.DVD :Auto b.VIDEO1 :Auto c.VIDEO2 :---- d.VIDEO3 :Auto e.VIDEO4 :Auto f.TAPE :---- g.CD :Auto h.PHONO :---- 4 ENTER ENTER 5 Use the Up and Down [ ]/[ ] buttons to select the input, and use the Left and Right [ ]/[ ] buttons to select: PCM, DTS, or Auto. PCM: The PCM indicator flashes, and only input signals in PCM format will be output. DTS: The DTS indicator flashes, and only input signals in DTS format will be output. Auto (default): The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead. Press the [SETUP] button. Setup closes. Note: • This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. ENTER 81