Optoma DV10 MovieTime User Manual - Page 52

Replacing the Lamp

Get Optoma DV10 MovieTime PDF manuals and user guides View all Optoma DV10 MovieTime manuals
Add to My Manuals
Save this manual to your list of manuals

Page 52 highlights

ENGLISH MAINTENANCE Replacing the Lamp The projector displays a warning message "Lamp is approaching the end of its useful life in full power operation. Replacement Suggested!" When you see this message, please contact your local reseller or service center. Make sure the projector has cooled down for at least 30 minutes before changing the lamp. Warning: Lamp compartment is hot! Allow it to cool 1 down before changing lamp! 3 2 4 Warning: To reduce the risk of personal injury, avoid dropping the lamp module or touching the lamp bulb. If dropped, the bulb may shatter and cause injury. Lamp Replacing Procedure: 1. Turn off the power to the lamp by pressing the power button. 2. Allow the projector to cool down at least 30 minutes. 3. Disconnect the power cord. 4. Use screwdriver to remove the screw from the cover.  5. Remove the cover.  6. Unscrew 2 screws from the lamp module.  7. Pull out the lamp module.  To replace the lamp module, reverse the above mentioned steps. 52 * DVD Projector

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
52
*
DVD Projector
MAINtENANcE
E
NGLISH
Replacing the Lamp
The projector displays a warning message “
Lamp is approaching
the end of its useful life in full power operation. Replacement Sug-
gested!
” When you see this message, please contact your
local
reseller or service center.
Make sure the projector has cooled down for at least 30 minutes
before changing the lamp.
Warning:
Lamp compartment is
hot!
Allow it to cool
down before changing
lamp!
Lamp Replacing Procedure:
1.
Turn off the power to the lamp by pressing the power button.
2.
Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4.
Use screwdriver to remove the screw from the cover.
5. Remove the cover.
6. Unscrew 2 screws from the lamp module.
7. Pull out the lamp module.
To replace the lamp module, reverse the above mentioned steps.
Warning:
To
reduce the risk of
personal injury, avoid
dropping the lamp
module or touching the
lamp bulb. If dropped,
the bulb may shatter
and cause injury.
1
2
3
4