Oreck DTX1400 Owners Guide - Page 8

ENGLISH Replacing Motor Filter Unplug unit from wall outlet. Remove the dustbag and carrier to access the motor filter grill. Using the tab located at top of filter grill, lift filter grill out of unit. Remove filter from grill and replace with new filter. Change the motor filter every fifth dustbag replacement. After filter has snapped into place, push filter upwards. Note: Replace Hepa Filter once a year or every fifth dust bag replacement. Replacing Exhaust Filter Unplug unit from wall outlet. Remove exhaust grill from back of unit by pressing down and pulling out on the tab located at the top of the grill. Discard used exhaust filter. Place new filter in grill. Set grill tabs in slots. Press top of grill to snap closed. The exhaust filter should be changed with every fifth dustbag replacement. Note: Exhaust filter not needed if Advanced Hepa Filter is used. ADVANCED HEPA FILTER INSTALLATION: Remove exhaust grill. Install Advanced Hepa Filter by aligning tabs in slots and pressing top to snap closed. Storage Turn unit off and unplug cord from outlet. Rewind cord by pressing cord rewind pedal. Do not allow plug to whip when rewinding. When storing DTX 1400A, stand vacuum cleaner on end. Insert telescopic wand clip into slot located on base of vacuum. The power nozzle assembly connected or disconnected will stand in an upright position. 8