Oregon Scientific LW301 User Manual - Page 6

EN Set Up Remote Temperature / Humidity Sensor lw301/302 1. Slide to open the battery compartment cover. 2. Slide channel switch to select a channel (1, 2, 3). Ensure you use a different channel for each sensor. 3. Place the batteries in the compartment following the polarity label +/-. 4. Press RESET after each battery change. 5. Align the cover flat against the battery compartment, then slide it until it clicks into place to lock the cover. NOTE Ensure to set at least one sensor to be channel one, the data of channel one will be shown on LIVE page in the application (page 8). Set Up rain gauge lw301 The rain gauge collects rain and takes rainfall readings. 1. Remove screws and slide the cover off in an upwards motion. 2. Place the batteries in the compartment following the polarity label +/-. Press RESET after each battery change. 3. Remove the fibre tape.  Set Up Weather sensor receiver lw301/302 For continuous use, connect the weather sensor receiver to Internet-connected hub using receiver connection cable provided. 1. Using provided LAN cable, connect one end to the ETHERNET socket on the Internet-connected hub and the other end to the router. 2. Using provided receiver connection cable, connect one end to the receiver connection socket (1 or 2) on the Internet-connected hub and the other end into the USB socket on the weather sensor receiver. on the weather sensor receiver. 3. Plug the large end of the power adapter into a power outlet not controlled by a wall switch. Plug the small end of the power adapter into the power socket on the Internet-connected hub. 4. Once connected, the weather sensor receiver will send the data to the Internet-connected hub via receiver connection cable. LED Light Continuously on Fast blink Slow blink Protracted blink Meaning Connection successful Searching Lost link No device found LW301_UM_EN_R8.indd 6 2012/8/14 3:06:15 PM