Oregon Scientific LW301 User Manual - Page 8

EN 2. On REG. STATION page, fill out all fields (you can find MAC ADDR. and REG CODE at the bottom of the Internet-connected hub). 3. The map displays your location. You can make a zoom by simply tap-and-drag the map by your two fingers at a time. Once you find out the specific location for your new station, press and hold until a red pin appears on the map. (Tap the red pin again, you can see New Station message pops up). Tap DONE to confirm the selection. 4. Once successful, LIVE page with real-time weather data will pop up. If application fails to connect to a station, the display goes back to REG.STATION page again. NOTE The default temperature and humidity data on LIVE page is from your channel 1 of temperature and humidity sensor. NOTE The weather icon represents the weather situation for the next 12 hours, not the real-time situation. NOTE Please save a copy of your MAC ADDR. and REG CODE for preventing the label faded or damaged that cannot be recognized for registration in the future. verify connection LW301/302 Before proceeding to install sensors outside, please verify communication and transfer of data. Enter MY WEATHER page, then tap HISTORY profile. To search for a sensor: Press and hold SEARCH (located at the back of the weather sensor receiver). NOTE Unit will search only for already registered sensor or new sensor reset within last 30 minutes. To register a new sensor, reset sensor prior to search. TIP The transmission range may vary depending on many factors. Sensors should be positioned in an open area away from trees or other obstructions. Relocate your sensor to various locations to have better reception. Mounting / Placing of sensors Wind Sensor LW301 Secure the sensor connector in the desired location: a. Align the back of the sensor connector to an existing pole. a b Secure in place by inserting the ends of the U-bolt into the holes on the sensor connector and securing it with washers and bolts.  LW301_UM_EN_R8.indd 8 2012/8/14 3:06:27 PM