Oregon Scientific WMR86 User Manual - Page 4
Set Up Remote Wind Sensor
View all Oregon Scientific WMR86 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
EN C 1. Funnel 2. Indicator OUTDOOR TEMPERATURE / HUMIDITY SENSOR 5 2 1 3 CF 4 1. Unscrew the anemometer from the wind sensor carefully. 2. Insert batteries matching the polarities (+ / -) and replace the anemometer. Press RESET after each battery change. SET UP REMOTE TEMPERATURE / HUMIDITY SENSOR The remote sensor can collect data from up to 3 channels. To set up the remote sensor: 1. Slide open the battery door. 2. Slide channel switch to select a channel (1, 2, 3). Ensure you use a different channel for each sensor. 3. Insert the batteries, matching the polarities (+ / -). 4. Press RESET after each battery change. 5. Close the battery door. SET UP RAIN GAUGE The rain gauge collects rain and takes rainfall readings. The sensor can remotely transmit data to the base station. To set up the rain gauge: 1. LED status indicator 2. RESET hole 3. °C / °F: Select temperature unit 4. CHANNEL switch 5. Battery compartment GETTING STARTED NOTE Install batteries in the remote sensors before the base station matching the polarities (+ and -). NOTE Use alkaline batteries for longer usage and consumer grade lithium batteries in temperatures below freezing. SET UP REMOTE WIND SENSOR The wind sensor takes wind speed and direction readings. The sensor is battery operated. It is capable of transmitting data to the base station wirelessly within an approximate operating range of 100 meters (328 feet). To insert batteries: 2 1 1. Remove screws and slide the cover off in an upwards motion. 2. Insert the batteries (2 x UM-3 / AA), matching the polarities (+ / -). Press RESET after each battery change. 3. Remove the fibre tape. SET UP BASE STATION NOTE Install batteries in the remote sensors before the base station matching the polarities (+ and -). 1. Slide open the battery door. 4