Panasonic 36PSU1U6 Installation Instructions - Page 23
Removing the Grille to Install the Indoor Unit
View all Panasonic 36PSU1U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
3-13. Removing the Grille to Install the Indoor Unit Basically, these models can be installed and wired without removing the grille. If access to any internal part is needed, follow the steps given below: How to remove the grille (1) Set the 2 flaps in the horizontal position. (2) Unscrew the 3 screws. (Fig. 3-28a) (3) Remove the grille. (a) Hold both corners of the air-intake grille, then pull out and up to open. (Fig. 3-28b) (b) Use a flathead screwdriver to push up the 3 tabs to remove the grille. (Fig. 3-28b) (c) Pull the lower part of the grille toward you to remove. (Fig. 3-28a) How to replace the grille (1) Close the flaps. (2) Reinstall the grille into the lower part while align- ing its tabs on the upper part. (Fig. 3-29a) Insert the tabs in the slots and push the lower part of the grille back into position. (3) Press at each of the 5 tabs to completely close the grille. Make sure that the grille and frame are firmly fitted together. (Fig. 3-29b) 3-14. Preparing the Indoor Side Tubing Arrangement of tubing by directions (a) Right tubing The corner of the right frame needs to be cut by a hacksaw or the like. (Fig. 3-30) (b) Right-rear or left-rear tubing In this case, the corner of the frame needs not be cut. To mount the indoor unit on the rear panel: (a) Hang the 3 mounting slots of the unit on the upper tabs of the rear panel. (Fig. 3-31) 23 1BOBTPOJD@1"$J@*OEPPS6OJU@64MF Air-intake grille Grille Fig. 3-28a Air-intake grille Fig. 3-28b Fig. 3-29a Fig. 3-29b Frame Right tubing outlet Fig. 3-30 Mounting slot Tab Fig. 3-31