Panasonic AGVP310 AGVP310 User Guide - Page 25

*Important: If a remote control button does not work when pressed, press the VCR button on the remote and try the button again. VCR Operation Review, Replace or Clear Program Contents: (Recording is not in progress) 1 Press PROG to display Program List. 2 P DT START STOP CH SPD 1 13 2:00p 3:20p 02 SLP 2 14 7:00p 7:30p 10 SP 3 4 Press to select number. CANCEL : ADD/DLT SELECT : SET : SET EXIT : PROG 3 To Replace program... P DT START STOP CH SPD 1 13 2:00p 3:20p 02 SLP 2 14 7:00p 7:30p 10 SP 3 4 Repeat Step 2 (p. 24) to set new programs. To cancel a Timer Recording in progress... Hold down STOP in VCR mode for a few seconds to cancel the Timer Recording. (The "TIMER" Indicator goes out on Multi Function Display.) • Any future daily or weekly recording will be performed as programmed. SELECT : SET : SET EXIT : PROG or To Clear program... P DT START STOP CH SPD 1 2 14 7:00p 7:30p 10 SP 3 4 Press ADD/DLT. SELECT : SET : SET EXIT : PROG 4 Press PROG to end the programming. Notes • If you are using a Cable Box, the VCR's channel for Timer Recording must be set to the Cable Box input channel and Cable Box must be manually set to the desired channel. Cable Box power must be left on. • 2 minutes before Timer Recording is performed, "PLEASE PREPARE FOR TIMER REC" appears and Timer Indicator flashes. Be sure a cassette with record tab is loaded and DECK is in Stop mode. • If a power interruption occurs while programming the timer, the timer program(s) may be canceled. If "TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION" appears on-screen, please re-enter the timer programs. • If the start time for Timer Recording comes up during recording and playing back, Timer Recording will not be performed. Important notes when using DSS Receiver • When recording programs via DSS Receiver, DSS Receiver must be left on. • When recording programs via an antenna or cable, DSS Receiver must be turned off. 25