Panasonic AGVP310 AGVP310 User Guide - Page 30

Tape Operation Search System For each recording, an invisible index mark is placed on the tape. A program index and information are also included for timer recordings. These marks are used to access or scan recordings. Zero Search To quickly return to a specified tape location. 1 Press DISPLAY during play to display Counter. Index Search 1 INDEX SEARCH ENTER INDEX NUMBER :1 USING 1- 9 KEYS FORWARD SEARCH :FF REVERSE SEARCH :REW EXIT :SEARCH Press SEARCH* to display SEARCH in Stop or Play mode, and then press NUMBER keys to select recording number. • To calculate number, see below. Press FF/SLOW+ or REW/SLOW- on the remote to start search. 2 INDEX SEARCH FORWARD SEARCH : FF REVERSE SEARCH : REW Play begins at search end. To search forward or back 1 index, press FF/SLOW+ or REW/SLOW- on the remote while screen left is displayed (10 sec.). • To cancel, press PLAY or STOP. To Calculate Index Number Example 1: To go to rec. 2 from rec. 4, enter 3 and press REW. 1 2 3 45 6 7 Example 2: To go to rec. 6 from rec. 2, enter 4 and press FF. 2 PLAY 1 2 : 0 0AM 0 : 00 : 00 SP Press COUNTER RESET on remote at desired position to reset to "0:00:00". 3 Continue to record, playback etc. 4 Press STOP. 5 REW 1 2 : 3 0AM CH 02 0 : 30 : 30 SP Press CM/ZERO in Stop mode to start Zero Search. STOP 1 2 : 3 1AM CH 02 0 : 00 : 00 SP • DECK will go into FF or REW mode and stop at the last point the Counter was set to 0:00:00. Commercial Skip DECK fast forwards (skips) over 1, 2, or 3 minutes of recorded tape as desired. 1 Press CM/ZERO in Play mode. • The skip time can be changed by pressing CM/ZERO repeatedly as shown by the figure below. PLAY 1st Press 1 min Skip 1 2 3 45 6 7 NOTE: indicates start points of each recording. Note • If Index Search is started very close to an index mark, that index mark may not be counted in the search. 30 2nd Press 2 min Skip 3rd Press 3 min Skip • No indication appears on-screen.