Panasonic AW-HN38H AW-HN38H Operating Instructions - Page 20

System example 1 (connection with commercially available controller, RS-232C daisy-chain connection)

Get Panasonic AW-HN38H PDF manuals and user guides View all Panasonic AW-HN38H manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Connections (continued) ■■System example 1 (connection with commercially available controller, RS-232C daisy-chain connection) AW‑HN40/AW‑HN38* Up to 7 Commercially available controller RS-232C connector RS-232C connector Supplied AC adaptor * You can connect up to seven cameras to a single controller. Supplied AC adaptor ●● Configure the service switches at the bottom of the unit. For details on the service switches, see "Service switch settings" (page 42). SW1 SW2 SW3 SW4 SW7 SW8 Camera address setting (standard serial communication) Set to AUTO or 1 to 7. (Set address numbers so that they do not duplicate each other.) Communication format Enable standard serial communication (ON). Communication baud Set to 9600 bps (OFF) or 38400 bps (ON) based on your commercially rate available controller. Communication connector Set to RS-232C (ON). ●● Configure the following items in the camera menu. 1. Display [System] menu  [Protocol]  [Model Select]. 2. Select [SEVIHD1], [SBRC300], or [SBRCZ330] for the protocol type. Supplied AC adaptor 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
20
Connections
(continued)
■
System example 1 (connection with commercially available controller,
RS-232C daisy-chain connection)
RS-232C
connector
RS-232C
connector
Commercially
available
controller
AW-HN40/AW-HN38*
Supplied AC adaptor
Supplied AC adaptor
Supplied AC adaptor
Up to 7
* You can connect up to seven cameras to a single controller.
●
Configure the service switches at the bottom of the unit.
For details on the service switches, see “Service switch settings” (page 42).
SW1
Camera address
setting (standard
serial communication)
Set to AUTO or 1 to 7.
(Set address numbers so that they do not duplicate each other.)
SW2
SW3
SW4
Communication
format
Enable standard serial communication (ON).
SW7
Communication baud
rate
Set to 9600 bps (OFF) or 38400 bps (ON) based on your commercially
available controller.
SW8
Communication
connector
Set to RS-232C (ON).
●
Configure the following items in the camera menu.
1.
Display [System] menu
[Protocol]
[Model Select].
2.
Select [SEVIHD1], [SBRC300], or [SBRCZ330] for the protocol type.