Panasonic CF-18DHAZXKM Notebook Computer - Page 35

10 At the confirmation message , press Y . The operation of reinstallation for the hard disk starts automatically. (The operations take about 20 minutes.) CAUTION Do not interrupt the reinstallation procedure before completion, for example by turning off the computer or pressing Ctrl + Alt + Del , as this may prevent Windows from starting up, or may cause data to be lost so that the reinstallation procedure cannot be executed. When a message appears instructing you to insert the next CD, insert the recovery CD showing the next number in the sequence, and then select [OK]. If the message [The media does not contain the correct file] appears, select [OK]. A message will appear instructing you to insert the next CD. Confirm that the proper recovery CD has been inserted by opening the cover of the CD/DVD drive and then close the cover, then select [OK]. 11 After the reinstallation procedure completes, this screen should appear. Remove the recovery CD, and then press any key. The computer will be shut down. [Recovery] is complete. Windows(R) XP Professional install wizard will start after reboot. Please remove the Product Recovery CD-ROM. After tuning off the power, disconnect the CD/DVD-ROM drive, and turn t-h-e--p-o-w--e-r-o-n--a-g-a-i-n 12 Remove the CD/DVD Drive. 13 Turn on the computer, and press F2 while [Panasonic] boot screen is displayed. The Setup Utility will start up. If the password has been set, enter the Supervisor Password. 14 Press F9 . At the confirmation message, select [Yes] and press Enter . (The Setup Utility settings will return to their default values. Even the security settings with the exception of the password(s) will return to their default values.) 15 Select [Exit] and then select [Save Current Values], then press Enter . At the confirmation message, select [Yes] and press Enter . 16 Turn the computer off by sliding the power switch. NOTE If additional instructions are included with the computer, be sure to read them. It may be necessary to perform additional operations during the following procedures. 17 Perform the first-time use operation ( page 13 step 6 - page 15 step 10 ). 18 Run the Setup Utility and change the settings where necessary. 35 Troubleshooting