Panasonic CT-20SL15 20" Ctv Orion Oem - Page 6

ENGLISH INSTALLATION Installation Television Location Follow these recommendations before deciding the location of your television. • Avoid excessive sunlight or bright lights, including reflections. • Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure. • Fluorescent lighting may reduce remote control transmitting range. • Keep away from magnetic equipment, including motors, fans and external speakers. WARNING: Use this television receiver only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. In order to avoid injury to children, never place your television receiver on a piece of furniture that is capable of being tilted by a child leaning on it, pulling on it, standing on it, or climbing on it. A falling television can cause serious injury or even death. Optional Cable Connections Shielded audio and video cables should be used between components. For best results: • Use 75-ohm coaxial shielded cables. • Use appropriate input and output connectors, that match your component connectors. • Avoid long cables to minimize interference. AC Power Supply Cord CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET AND Polarized plug FULLY INSERT. DO NOT USE A PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT FROM THE APPARATUS. Cable / Antenna Connection For proper reception, either a cable or Incoming Cable from antenna connection is required. Cable Company Cable Connection Connect the cable supplied by your local cable company. Tighten with fingers only. Use of any tool (e.g. pliers) for tightening may result in tuner damage. 75 Ohm VHF/UHF on back of TV Note: A cable converter box may be required for proper reception. Check with your local cable company for compatibility requirements. Antenna Connections For proper reception of VHF/UHF chan- Incoming Cable from nels, an external antenna is required. Home Antenna For best reception an outdoor antenna is recommended. Note: Cable Mode is preset at the factory. Antenna users must change to TV Mode in the Set Up menu (page 12). Remote Control Battery Installation Requires two AA batteries (supplied). Battery Polarity AA / 1.5V 1 2 AA / 1.5A AA / 1.5V AA / 1.5A 3 Procedure 1. Turn the remote control face down. Remove battery cover by pressing down on the marking on the cover and sliding it off in the direction indicated. 2. Install batteries matching (+) and (-) polarity signs. 3. Replace the battery cover by sliding in reverse until the lock snaps. Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control. Precautions • Replace batteries in pair. • Do not mix battery types (zinc carbon with alkaline). • Do not recharge, heat, short-circuit, disassemble, or burn batteries. 4