Panasonic Full HD 3D Home Theater Projector Spec Sheet - Page 11

SPEC FILE Full High-Definition Home Cinema Projector PT-AE8000 Control commands Command PON*1 POF*1 IIS OMN OEN OBK OCU OCD OCL OCR OLE OST O3D OFZ FC1 OSH*2 OVM OWM VS1 VPM OOT OMM DPA DCM OVL OSM KST DAM OAS Function Standby power on Standby power off Input signal selection Menu Enter Return Cursor up Cursor down Cursor left Cursor right The same function as "LENS" button Default The same function as "3D" button Freeze The same function as "FUNCTION" button Blank on/off Picture mode switch Waveform monitor activate/off Aspect switch Picture mode Off timer The same function as "MEMORY LOAD" button The same function as "PICTURE ADJUSTMENT" button Color management menu The same function as "VIERA Link" button The same function as "SUB MENU" button Keystone correction "ADVANCED MENU" function Auto setup (for COMPUTER IN only) Parameter - - CP1, SVD, VID, HD1, HD2, HD3, RG1 0, 1 - - - 0, 1, 2, 3, 4, 5, 6, 7, 8 - NOR, DYN, 709, DCN, CN1, CN2, GM1 0, 1, 2, 3, 4, 5, 6, 7 Option Menu Command VXX Lens memory Gamma output level (Y) Gamma output level (R) Gamma output level (G) Gamma output level (B) Gamma input level Trigger 1 output Trigger 2 output 3D INPUT FORMAT LMLI0=+00000 - LMLI0=+00005 AGOS0=010000 - AGOS0=090255 AGOS1=010000 - AGOS1=090255 AGOS2=010000 - AGOS2=090255 AGOS3=010000 - AGOS3=090255 AGIS0=01000 - AGOS0=09100 TROI0=+00000 - TROI0=+00001 TROI1=+00000 - TROI1=+00001 DIFI1=+00000 - DIFI1=+00004*3 *1 PON is the only command that is effective in standby mode; all other commands are invalid. The PON command is not accepted during lamp on control. After the lamp has been turned off and while the cooling fan is still operating, lamp on control will not be activated for about 85 seconds in order to protect the lamp. *2 Do not send OSH commands continuously in a short period of time. Doing so may burst the lamp or shorten the lamp replacement cycle. *3 DIFI1=+00002 is unused. As of August 2012 SFL12M016 11/13