Panasonic Full HD 3D Home Theater Projector Spec Sheet - Page 13

SPEC FILE Full High-Definition Home Cinema Projector PT-AE8000 Command example To set the input to HDMI 1, send the command as shown below. NOTE: When sending commands without parameters, a colon (:) is not necessary. STX Start IIS : HD1 ETX Command Parameter End Notes on projector placement and operation The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the following precautions. 1. Never place objects on top of the projector while it is operating. 2. Make sure there is an unobstructed space of 100 mm (3-15/16 inches) or more around the projector's air intake openings. 3. If the projector is placed in a box or enclosure, ensure the temperature of the air surrounding the projector is between 0°C and 35°C (32°F and 95°F). Also make sure the projector's intake and exhaust openings are not blocked. Take particular care to ensure that hot air from the exhaust openings is not sucked into the intake openings. 100 mm ( 3-15/16 in) or more 100 mm ( 3-15/16 in) or more 100 mm ( 3-15/16 in) or more Direction of air intake and exhaust Intake Exhaust Operating the projector continuously 1. If the projector is to be operated continuously 6 hours or more, lamp replacement cycle duration becomes shorter. 2. The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short periods. Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice. Product availability differs depending on region and country. This product may be subject to export control regulations. All other trademarks are the property of their respective trademark owners. As of August 2012 SFL12M016 13/13