Panasonic KXTG2335 KXTG2335 User Guide - Page 56

Troubleshooting If the handset display shows error messages, see "If the Following Appear on Your Display..." (p. 55) for the Cause & Remedy. Problem Cause & Remedy "No link to base. Move closer to base, try again." is displayed and an alarm tone sounds. • You are too far from the base unit. Walk closer to the base unit. • Confirm the base unit's AC adaptor is plugged in. • Raise the base unit antenna. • If the above remedies do not solve the problem, the handset may have lost communication with the base unit. Register the handset again (p. 49). The handset and/or base unit does not work. • Check the settings (p. 8-10). • Check whether the dialing mode setting is correct (p. 13). • Fully charge the battery (p. 9). • Clean the charge contacts and charge again (p. 10). • Check battery Installation (p. 9). • Unplug the base unit's AC adaptor to reset it. Plug in, and try again. • Re-install the battery (p. 9) and fully charge it. Static, sound cuts in/out, fades. Interference from other electrical units. • Move the handset and base unit away from other electrical appliances (p. 3). • Walk closer to the base unit. • Raise the base unit antenna. The handset and/or base unit • The ringer volume is turned off. Set to high, does not ring. medium, or low (p. 15, 16). The handset display is blank. • If the handset display is blank, fully charge the battery (p. 9). You cannot program any function items. • Programming is not possible while the handset and/or base unit is being used. • Do not pause for over 60 seconds while programming. • Walk closer to the base unit. While programming or searching, the handset starts to ring and the program/ search stops. • A call is coming in. To answer the call, press [C], [s] or [SP-PHONE]. Start again from the beginning after hanging up. You cannot make an intercom/ • If the handset or base unit is in use, you may outside call. not be able to make a call. Try again later. 56