Panasonic KXTG2357 2.4ghz Cdl Tot 2 H/s - Page 58

Listening to Messages Using the Handset (Remote Operation) Handset If "New message" is displayed on the handset, new messages have been recorded. • If the Message Alert is turned on (p. 24), the Ringer/Message Alert indicator on the handset will flash slowly when new messages have been recorded and the handset is not in use. To play back messages 1 Press [MENU]. 2 Press Select at "Message play". • The unit announces the number of new messages and only new messages are played back from the speaker. To switch to the receiver, press [C]. To switch back to the speaker, press [s]. • When you have no new messages, the unit announces "No new messages. All message playback" and plays back all messages. • When you have no messages, the unit announces "No messages". • To play all messages, press [5]. • If you do not press any button, the voice menu will start (see below). 3 To end remote operation, press [OFF]. Message play KBack dB SelectL MENU=Call back @4 =Erase msg KRepeat SkipL • If a call is received during playback, the unit rings and playback stops. To answer the call, press [C] or [s]. For playback, start again from the beginning after hanging up. • At the end of the last message, "End of final message" is heard. The unit will announce the remaining recording time if it is less than 3 minutes. • If you hear "Memory full" after playback, erase unnecessary messages (p. 60). • When memo messages are played (p. 61), "MEMO" is displayed. Voice menu If you do not press any buttons at the end of the last message, the unit will announce "End of final message" and the voice menu will begin. The unit announces, "Press 4 to play back new messages. Press 5 to play back all messages." • You can press buttons for other playback options (p. 59) even if the voice menu has started. • If you do not press any button within 10 seconds after the voice menu, the handset will exit remote operation. 58