Panasonic MCV5204 MCV5204 User Guide - Page 30
REPLACING BELT, Loop new belt Panasonic Type UB8
View all Panasonic MCV5204 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
+ + + Replacing Belt ➢ Replace belt whenever a burning rubber smell caused by excessive slippage occurs. Lift Agitator Up Unidad del agitador Soulever l'agitateur Motor Shaft Arbre d'entraînement du moteur Eje del motor + + + ➢ Remove lower plate. ➢ Remove agitator by carefully lifting out. ➢ Remove worn or broken belt. ➢ Clean agitator. ➢ Loop new belt (Panasonic Type UB8 only) around motor shaft and agitator pulley; see illustration for correct belt routing. ➢ Reinstall agitator back into nozzle housing grooves. ➢ After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely. ➢ Reinstall lower plate. Groove Ranura Ouverture End Cap Tapa del extremo Bouchon - 30 -
- 30 -
Replacing Belt
+
+
+
Lift Agitator Up
Unidad del agitador
Soulever l’agitateur
Motor Shaft
Arbre d’entraînement
du moteur
Eje del motor
+
+
+
End Cap
Tapa del extremo
Bouchon
Groove
Ranura
Ouverture
➢
Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢
Remove lower plate.
➢
Remove agitator by carefully lifting
out.
➢
Remove worn or broken belt.
➢
Clean agitator.
➢
Loop new belt (Panasonic Type UB8
only) around motor shaft and agitator
pulley; see illustration for correct belt
routing.
➢
Reinstall agitator back into nozzle
housing grooves.
➢
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
➢
Reinstall lower plate.