Panasonic PT-D5600E Dlp Projector- English/french - Page 44
LAMP UNIT REPLACEMENT STEPS, Open the fan unit as shown in
View all Panasonic PT-D5600E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Replacing the lamp unit Lamp unit replacement steps Attention • After 1 500 hours (4 000 hours when long life lamp units are used) of operating the same lamp, it is only possible to operate the unit for approximately 10 minutes. Steps to must be completed within 10 minutes. Turn the power off by following the steps on page 24, remove the power plug and confirm that the surroundings of the lamp unit have cooled off. Check that the fan has stopped running. Have a Phillips screwdriver ready ahead of time. Remove the screw securing the lamp unit cover, and then slide the lamp unit cover a little toward the left, and remove it. Lamp unit cover Lamp unit 2 Lamp unit Fixing screws Remove the two screws securing the fan unit. Note • The lamp units are constructed in such a way that the screws in steps and will not fall through completely. Open the fan unit as shown in the figure. Handle Lamp unit 1 Caution The lamp unit will be hot after it has been used. You might get burned if you touch it while it is still hot. Remove the screws securing the lamp units (two for each unit), take hold of the handles, and remove the lamp units. Install the new lamp unit. Use a Phillips screwdriver to securely tighten the 2 lamp unit fixing screws (two for each unit). Secure the two screws for securing the fan unit tightly. Slide the cover a little toward the right, and secure it using the screw for securing the lamp unit cover tightly. Attention • Firmly install the lamp unit and lamp unit cover. If not installed firmly, a protection circuit will function and the power will not be turned on. 44