Panasonic PV20DF63 PV20DF63 User Guide - Page 10

Initial Setup (Ready to Play) Please make all cable or antenna connections before powering on. Connections For ANT./Cable Connect the cable from Antenna/Cable to the VHF/UHF terminal on the unit. For DSS/Cable Box Connect the OUT jack on your cable box to the VHF/UHF terminal on the unit with a RF cable. VHF/UHF VHF/UHF IN from ANT./CABLE Cable TV Converter Box WARNING Overtightening "Nut type" RF coaxial cables IN from may damage jacks. Finger tighten only. VHF/UHF ANT./CABLE Initial Setup (Ready to Play) 1 Plug the unit power cord into an AC wall outlet. 2 Press POWER* on the remote or unit. The unit comes on and auto channel and clock set starts. VHF/UHF If AUTO CLOCK SET IS INCOMPLETE screen appears, set the clock using MANUAL CLOCK SET procedure on next page. CH AUTO SET PROCEEDING AUTO CLOCK SET PROCEEDING CANCEL : PRESS STOP KEY • If you use a cable box, turn it on and set it to the Public Broadcasting Service (PBS) channel in your time zone. If you use a DSS receiver, it must be turned off. 3 Settings are made automatically. When setup is done, this screen appears. 2/ 6/2003 THU 12:00PM DST : ON SETT ING : CH 10 AUTO CLOCK SET COMPLETED AUTO CLOCK SET I S I NCOMPLETE PLEASE SET CLOCK BY PRESSING ACT I ON KEY Notes • Function buttons are inoperative during Initial Setup. • Depending on conditions, Auto Clock Set may take longer than 30 minutes. If so, press STOP to stop setup and perform settings manually. (See page 12-13.) 10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]