Panasonic SL-1000 Owners Manual - Page 12
English, Tone arm height, Armlift height
View all Panasonic SL-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Adjustment (continued) Tone arm height Make this adjustment only if the cartridge you are using makes it necessary. Preparation z Put a record on the turntable. 1 Release the arm lock. 3 After arm height adjustment is finished, lock the tone arm by turning the arm lock knob. z Be sure to turn the arm lock knob to the end as shown in the figure below. You may need to apply some force to do so. Arm lock (Released) (Locked) 2 Adjust the height with the arm-height control ring. Adjust the arm-height until the tone arm becomes parallel to the record. Turn the arm-height control ring to align the position mark with the index line. 0 to 15 mm are marked on the arm height control ring. "/5*4,"5*/( Remove the stylus cover, taking care not to damage the stylus, then release the arm clamp. Lower the cue lever, rest the stylus on the record and adjust the height control until the tone arm and record are parallel. Parallel to a record Index line Arm-height control ring Attention z Selecting a smaller scale mark lowers the arm-height control ring. Prevent an object from being caught by the arm-height control ring. 22 (22) English Attention z Be careful not to damage the stylus tip. z Do not use the product with the arm lock released. z For finer adjustment, use a level (not included) to adjust the arm-height so that the cartridge becomes parallel to a record. Armlift height Make an adjustment according to your cartridge if necessary. Preparation z Put a record on the turntable. z Remove the stylus cover, taking care not to damage the stylus, then release the arm clamp. z Lift the cue lever and move the tone arm over the record. 1 Check the armlift height (distance between the stylus tip and record surface). If adjustment is needed, go to step 2 . 2 Return the tone arm to the arm rest, clamp it with the arm clamp and while pressing the armlift down with your finger, turn the screw to adjust the height. z Turning the screw clockwise lowers the armlift. z Turning the screw anti-clockwise raises the armlift. Armlift Armlift screw Arm clamp 23 (23) English Getting started