Pfaff select 1528 Owner's Manual - Page 48
Trouble-shooting
View all Pfaff select 1528 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Maintenance and trouble-shooting Trouble-shooting The machine skips stitches The needle is not properly inserted. The wrong needle is inserted. Needle is bent or blunt. Machine is not properly threaded. Needle is too small for thread. Push needle fully upwards, flat side facing the back. Use a needle system 130/705 H. Insert a new needle. Check how machine is threaded. Use a larger needle. Needle thread breaks See reasons above. Thread tension is too tight. Thread is poor or has slubs in it, or has become dry after too-long storage. Thread is too thick. See above. Adjust thread tension. Only use good threads. Use needle with large eye (System 130 N). Needle breaks off Needle is not pushed fully in. Needle is bent. Needle is too thick or too thin. Needle is bent, and has hit the needle plate because you are pulling or pushing the fabric. The bobbin case is not properly installed. Insert new needle and push fully in. Insert new needle. Insert new needle. Let the machine feed the fabric. Only guide the fabric lightly. When you insert the bobbin case, push it fully into the stop. Seam is sewn unevenly The tension needs adjusting. Thread is too thick, slubbed or hard. The bobbin thread is unevenly wound. Thread bunching at top or bottom side of fabric. Check needle thread tension. Only use perfect threads. Do not wind thread free-hand, but run it on through the winding tension. Thread up correctly. Check needle thread tension. 3:4