Philips 20PF5120 Quick start guide - Page 4
Direct cable connections - remote control
UPC - 037849962930
View all Philips 20PF5120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ANTENNA TV A combination antenna receives normal broadcast channels (VHF 2-13 and UHF 14-69). Your connection is easy because there is only one 75 Ω (ohm) antenna jack on the side of your TV, and that's where the antenna goes. 1 If your antenna has a round cable (75 ohm) on the end, then you're ready to connect it to the LCD TV. If your antenna has flat, twin-lead wire (300 ohm), you first need to attach the antenna wires to the screws on a 300- to 75-ohm adapter(not supplied). 2 Connect the antenna (or adapter) to one end of the supplied L-Adapter as shown, and connect the other end of the L-Adapter to the TV jack on the side of the LCD TV. 3 Plug the DC adapter into the DC IN 16V jack on the LCD TV. Plug the power cable into an outlet and switch TV set on. 4 Run the AUTO PROGRAM function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto program function to set up the channels , your television may not operate properly. HELPFUL HINT • Remember, an antenna or cable TV signal must first be connected to your LCD TV. • Please make sure that you have selected the TV mode with AV+ key on your remote control, before installing TV channels. TV DC IN 3 16V Outdoor or Indoor Antenna (Combination VHF/UHF) DC Adapter Twin-lead wire to 300-75Ω adapter Power Cable DVI-I IN AUDIO IN DVI (HDCP / PC ANALOG) Television 12 OR Antenna with 75 Ω cable BASIC CABLE TV CONNECTION Your Cable TV input into your home may be a single (75 ohm) cable or use a cable box decoder. In either case the connection is very simple. Follow the steps below to connect your cable signal to your new television. Direct cable connections: 1 Connect the Cable TV signal to one end of the supplied L-Adapter as shown, and connect the other end of the adapter to the TV jack on the LCD TV. 2 Plug the DC adapter into the DC IN 16V jack on the LCD TV. Plug the power cable into an outlet and switch TV set on. 3 Run the AUTO PROGRAM function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto program function to set up the channels , your television may not operate properly. HELPFUL HINT • Remember, an antenna or cable TV signal must first be connected to your LCD TV. • Please make sure that you have selected the TV mode with AV+ key on your remote control, before installing TV channels. The Cable TV signal from Cable Company (75 Ω coaxial cable) L Adapter TV 1 DC IN 16V 2 Power Cable DVI-I IN AUDIO IN DVI (HDCP / PC ANALOG) 4