Philips 26PFL4507/F7 User Manual - Page 13

Note •• If you are not receiving a signal from your cable service, contact the Cable provider. •• If you press or MENU / EXIT during autoprogram, this setup of TV channels will be canceled. •• The initial autoprogram function can be executed for either Antenna or Cable only once.When you change the connection (Antenna / Cable), set Autoprogram again. ➠ p. 20 •• If there is no signal Input from the antenna terminal and no operation for several seconds after you Turn On the unit, helpful hints appears. Follow the instructions listed on the TV screen. Initial setup No channel is registered. Try Autoprogram again? Verify that you have a cable connected to the "ANTENNA IN" jack on the back of the TV, the channel installation process searches this connection. If you are using a cable or satellite box, please confirm the input which you have connected to the box and press "SOURCE" key on the remote control to select the appropriate source input.  Retry Later Select OK Skip After an initial setup is completed... • If you want to scan the channels automatically again. Autoprogram ➠ p. 20 • You can add the desired cable and Analog channels unmemorized by autoprogram. Add channels ➠ p. 21 • If you want to change to another language. Language ➠ p. 27 • If you want to change the location setting. Location ➠ p. 27 • If you want to restore the picture setting. Settings assistant ➠ p. 19 13 English