Philips 26PFL4507/F7 User Manual - Page 20
Sound, Setup, Autoprogram, Auto sound, Standard, Equalizer, SRS TruSurround XT, Auto volume leveling
View all Philips 26PFL4507/F7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Sound Before you begin: You must set Home in Location. ➠ p. 27 Otherwise, personalized picture and sound settings will not be memorized after the unit goes into Standby mode. 1 Press MENU / EXIT and use ▲▼ to select Sound, then press OK. Picture Sound Setup Features Language USB Auto sound Equalizer SRS TruSurround XT Auto volume leveling TV speakers Audio Setting Standard On Off On Stereo 2 Use to select the item you want to adjust, then press OK. Auto sound to select the desired setting, then press OK. (Personal, Standard, Vivid, Sports, Movie, Music and News) When you adjust the following settings (Equalizer, SRS TruSurround XT and Auto volume leveling), Personal will be set automatically. Adjust the tonal quality for each frequency. Cursor ◄ Cursor ► Equalizer to adjust the each level of tonal quality Press BACK to go back to the previous menu. This selects sound modes for more spatial or surround sound reproduction. Off to set SRS TruSurround XT® to Off SRS TruSurround XT On to set SRS TruSurround XT® to On This function keeps a constant loudness differential between the TV commercials and the programs. Auto volume leveling Off to remove the auto volume leveling On to reduce volume differences between the TV commercials and the programs You can select the Audio Output from the unit's speakers or not. If your amplifier is HDMI link function compatible and connected by an HDMI cable to this unit, some sound operations such as volume up can be changed by using this unit's remote control. Make sure Master EasyLink is set to On. ➠ p. 26 On to output sound from the unit's speakers TV speakers Off not to output sound from the unit's speakers Speakers EasyLink to control Audio Output from your connected EasyLink Compliant Devices with VOL + / − by using this unit's remote control. You can set the output mode as a default for the sound mode (Analog TV only). This setting is not interlocked when you change the output mode by pressing SAP. Refer to Switching audio mode. ➠ p. 16 Stereo to output stereo-audio Audio Setting Mono to output mono-audio SAP to output second audio program 20 English Setup Before you begin: Make sure the unit is connected to antenna or cable. 1 Press MENU / EXIT and use ▲▼ to select Setup, then press OK. Picture Sound Setup Features Language USB Autoprogram Channel list Add channels Antenna 2 Adjust the following items. Autoprogram Be sure the RF cable is correctly connected to this unit and you are registered with your cable TV provider when you install Cable channels. 1 Use ▲▼ to select Autoprogram, then press OK. • If you run Autoprogram when you have locked channels, a message appears asking to enter your PIN . Enter your PIN in order to complete the installation.You need to set the channel lock again after the installation. 2 Use ▲▼ to select an appropriate option, then press OK. -- When Antenna is selected, the TV detects antenna signals. It searches for DTV and Analog TV channels available in your area. -- When Cable is selected, theTV detects signals supplied by cable. It searches for DTV, Analog TV and Cable channels available in your area. Picture Sound Setup Features Language USB Autoprogram will rescan all channels. Auto programming may take more than 20 minutes to complete. Back Antenna Cable Select your signal source. Antenna Cable Or ANTENNA IN Continued on next page.