Philips AZ101817 User manual - Page 4

OPEN English Power Supply Batteries contain chemical substances, so they should be disposed of properly. Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst.Therefore: • Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. • When inserting new batteries, do not try to mix old batteries with the new ones. • Remove the batteries if the set is not to be used for a long time. Using AC Power 1 Check if the power voltage, as shown on the type plate located on the bottom AC MAINS ~ of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the AC MAINS inlet and the wall outlet.The power supply is now connected and ready for use. 3 To switch off completely, unplug the power cord from the wall outlet. • Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms. The type plate is located on the bottom of the set. Switching power on/off: Save energy Whether you are using mains or battery supply, to avoid unnecessary energy consumption always adjust the POWER slider to TAPE/OFF and check if the cassette keys are released. AZ1018 CD RADIO CASSETTE RECORDER PAUSE STOP • OPEN SEARCH LIFT TO PLAY CMDWFTMAOP FF RECORD POWER VOLUME PLAYPAUSE STOP BATT LOW SEARCH CPDROMGORDAEM FM•AM PRESET General operation 1 To select your sound source adjust the POWER slider to CD, RADIO or TAPE/OFF. 2 Adjust the sound with the VOLUME and DBB (Dynamic Bass Boost) controls. 3 To switch off the set, adjust the POWER slider to TAPE/OFF position and check the cassette keys are released. Note:When the set is switched off the tuner presets will be retained in the set's memory. 9