Philips AZ1145 User manual - Page 10

English BASIC FUNCTIONS GENERAL INFORMATION Switching on and off • Adjust the POWER slider to the desired sound source: CD, TUNER or TAPE/OFF. • The set is switched off when the POWER slider is in the TAPE/OFF position and the keys on the tape deck are released. ™ The volume and tuner presets will be retained in the set's memory. Adjusting volume and sound 1. Press the VOL +, - controls to increase or decrease VOLUME (or press 3 or 4 on the remote control). 2. Adjust the DBB control to select dynamic bass boost on or off. PHILIPS demo mode 1. On the set, press the CD STOP 9 button for 5 seconds. ™ PH..IL ..IPS scrolls across the display continuously. 2. To return to the current display you can either: • press any function button on the front panel. This interrupts the demo mode for 30 seconds; • press the CD STOP 9 button for 5 seconds. PH..IL ..IPS scrolls once before the demo mode is cancelled. GENERAL INFORMATION General maintenance • Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. TAPE OFF CD TUNER BATT LOW VOL DBB DYNAMIC BASS BOOST PAUSE STOP•OPEN PLAY•PAUSE SEARCH CD PROGRAM REPEAT ALL PLAY RECORD REMOTE SENSOR TAPE OFF CD TUNER BATT LOW VOL DBB DYNAMIC BASS BOOST PAUSE STOP•OPEN PLAY•PAUSE SEARCH CD PROGRAM REPEAT ALL PLAY RECORD REMOTE SENSOR DYNAMIC BASS BOOST PAUSE STOP•OPEN PLAY•PAUSE SEARCH CD MODE STOP CD PROGRAM REPEAT ALL PLAY RECORD REMOTE SENSOR SEARCH PROGRAM Safety information • Place the set on a hard and flat surface so that the system does not tilt. Make sure there is adequate ventilation to prevent the system from overheating. • The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. 10