Philips DC6210 User manual - Page 11

3 Get started Caution • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus.The model number and serial number are on the rear of the apparatus.Write the numbers here: Model No Serial No Mounting the set under your kitchen cabinet Preparation Note • Ask a friend or a professional personnel to safely mount the product under your kitchen cabinet. a Template b a. Find a mounting location near a wall outlet. b. Use the mounting template to test the design and thickness of your kitchen cabinet. c. Decide whether you want to connect the set with other audio/video equipment. Mounting the set For full details on how to use the Mounting Kit, please refer to the printed instructions in the Quick Start Guide and Template. Mount it Ask a friend to help you mount the unit as it is quite heavy. A Recommended depth of cabinet at the rear to allow for connections & Cut the template to fit inside the cabinet. A & Align the template border marked "FRONT" along the front edge of your cabinet. & Use adhesive tape to fix the template. & Drill 1/4 inch holes (size X.X mm diameter, X Template inch), as marked X on the template. FM & Remove the template when you finish drilling. Use 1/4" drill Tip - Use a nail to start each drill hole. - Hold your drill firmly at 90o with the cabinet bottom and drill holes at low speed. - Clear wood shavings. B Using the spacers On the spacers, there are 4 pairs of notch length options. Depending on the thickness of you cabinet bottom (with/ without an overhang), these notch lengths correspond to the 4 notch height in the space holders, and allow you to adjust to the B Spacer best height to help you mount the unit. & Measure the height of the cabinet bottom and/overhang. & Turn the spacer counterclockwise to determine which of the 4 heights is most suitable: High & & Low & Inser t the spacers accordingly. L (Low) Arrow L C & Manually fasten the 4 screws down into the spacer holder holes to mount your set. If the C overhang is more than 1 1/4 inch, use longer screws (not included). FRONT Tip To prevent damage to your set, do not use an electric drill to secure screws when mounting! - Hold the unit horizontally when installing it, since the CD tray may open if the unit is shaken. - Use the cable manager to manage excess power cord length. Warning • Never plug in the AC power cord to the power outlet before installation is completed. • Do not use a converter or extension cord. • Install the set as far as possible from sources of interference, such as a refrigerator, microwave oven, fluorescent lamp, etc. • There should be at least 2.5" distance between the unit and the wall. Install remote control battery Caution • Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. • Risk of decreased battery life! Never mix different brands or types of batteries. • Risk of product damage! When the remote control is not used for long periods, remove the batteries. Note • Batteries contain chemical substances, they should be disposed of properly. • Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/ perchlorate. EN 11 English