Philips FWC788 User manual - Page 25

English Clock/Timer 2 Press CD, TUNER or TAPE to select the desired source. G Before setting timer, make sure the music source has been prepared. CD - Load the disc(s).To start from a specific track, make a program (refer to "CD Operation - Programming the disc tracks"). TUNER - tune to the desired radio station. TAPE - load the prerecorded tape into tape deck 2. 3 Press à or á on the system repeatedly to set the hour for the timer to start. 4 Press í or ë on the system repeatedly to set the minute for the timer to start. 5 Press CLOCK•TIMER to store the start time. ➜ "TIMER ON" will be displayed and followed by the set timer "XX:XX" and then the selected source. ➜ TIMER will remain on the display. G At the preset time, the selected source will play. Sleep Timer Setting The sleep timer enables the system to switch to Standby mode automatically at a preset time. 1 Press SLEEP on the remote control repeatedly to select a preset time. ➜ The selections are as follows (time in minutes): 15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 ... ➜ "SLEEP XX" or "OFF" will be displayed. "XX" is the time in minutes. 2 When you reach the desired length of time, stop pressing the SLEEP button. ➜ SLEEP will appear on the display, except for "OFF" mode. ➜ The Sleep Timer is now set. Before the system switches to standby mode, a countdown of 10 seconds will be displayed. "SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1" ™ "SLEEP" To exit without storing the setting G Press Çon the system. Notes: - If the selected source (CD) is not available when preset timer is reached,TUNER will be selected automatically. - During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically. To deactivate the TIMER G Press TIMER ON/OFF on the remote control. ➜ The display will show "CANCEL" and TIMER will disappear from the display. While SLEEP mode is activated To check the remaining length of time G Press SLEEP once. To change the preset sleep timer G Press SLEEP twice. ➜ The display will show the remaining time followed by the sequence of sleep timer options. To deactivate the Sleep Timer G Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button. To activate the TIMER G Press TIMER ON/OFF on the remote control. ➜ The last set timer information will be shown for a few seconds and TIMER will appear on the display. pg 001-029/C788/37-Eng 25 25 12/11/01, 5:32 PM 3139 115 21181